WATER DISPENSER USP ​​is a device equipped with a microprocessor controller, designed for measuring the flow of water required. Especially useful for metering of water is needed in various technological processes carried out periodically, eg in the processes in the food industry (bakery, confectionery, pasta production, etc.)

USP WATER DISPENSER is designed to collect water directly from water mains.
Additionally dispenser can be controlled remotely from a PC which allows a convenient way to remotely control the operation of the device, eg from the office. Dispensers of our production are new, yet proven and tested product that is constantly improved and developed based on feedback from existing users.

All dispensers are fully automatic. Thanks to modern solutions, eliminating the mechanical dial. Control unit is an electronic dispenser USP microprocessor controller designed and manufactured by our company based on the latest electronics. Driver software is also done in our company so we can immediately respond to the suggestions reported by current users. Devices have built-in automatic adjustment of water temperature during dosing, depending on the temperature of the water already poured out. This allows water to obtain the desired temperature without having to dump the water. Moreover, the devices have self-learning function, which helps shorten the minimum time to reach the desired temperature.

Actuators (solenoids, actuators, valves, mixers, flow sensors) mounted dispensers are of the highest quality and are manufactured by world-renowned companies such as: Rossweiner, Danfoss, Esco, Hankook Gas and others.

water connections	How to Connect	Screw connection ½ / ¾ inch or hose ½ / ¾ inches
programming	The programming	Using the keypad, 4 function keys, 5 keys to set values​​, the two modes of operation 20 programs: the quantity and temperature of the water
	The work programs (version PROG) Programmable parameters: temperature correction flow coefficient	+/- 5 °C 10.0 - 90.0 typical: 74.0 for ½ inch                                    18.0 for ¾ inch
Setting	set to size: Measured quantity of water Outflow water temperature (programmable from the keyboard)	0.1 - 99.9 liters (or 1-999 liters) 1 -70 °C
water pressure	maximum	5 bar
flow	minimum	1.50 l/min for ½ inch 3.00 l/min for ¾ inch
	maximum	25.0 l/min for ½ inch 60.0 l/min for ¾ inch
	measurement error	+/-1.5%
Power Supply	voltage	230VAC +/-10% 50Hz
	Maximum power consumption	13VA
alarms	Over range (alarm at 97 deg C)	Intermittent light and audible signal
	Temperature sensor failure	Intermittent light and audible signal
	No signal from flow sensor with an open discharge	Intermittent light signal
	Presentation by signals from the sensor with a closed discharge	Continuous light signal and the intermittent sound
other	memory	Protection against loss of supply voltage, nonvolatile flash memory parameter to the setting, the memory 100 most recent operations.
	digital display	3 + 2 digits (red 14 mm)
	degree of protection	From the front IP54, IP20 total
	installation Category	I
	degree of pollution	I
	fuse	2 x 500 mA type M or T
	operating temperature	0 - 45 ° C
	humidity	80% without condensation
	weight	3.2 kg - 1/2 inch Policarbon 4 kg - 1/2 inch stainless steal 4.7 kg - 3/4 inch Policarbon 5,5 kg - 3/4 inch stainless steal
	Case Size	WxSxG (190x380x140mm)
	Hole Spacing	255 - polycarbonate 225 - stainless Steel
	housing material	PC (polycarbonate) or stainless steel
	Faceplate Color	gray