FEEDER ADJUSTABLE WATER FLOW is a device equipped with a microprocessor controller, designed to regulate the flow of water dispensed. Particularly useful is the dispensing process water administered continuously by flow rate, eg the production of pasta.

WATER DISPENSER is designed to collect water from the water supply network. The device is continuously measured in both flow rate and flowing water and its temperature and presents the information on the displays. Dispenser continuously adjusts the flow rate of water.

Dispensers of our production are new, yet proven and tested product that is constantly improved and developed based on feedback from existing users.

Control unit is an electronic dispenser USP microprocessor controller designed and manufactured by our company based on the latest electronics. Driver software is also done in our company so we can immediately respond to the suggestions reported by current users.

Actuators (solenoid valves, flow sensors) mounted dispensers are of the highest quality and are manufactured by world-renowned companies such as: Rossweiner, Danfoss, Esco, Hankook, and others.

water connections	How to Connect	Screw connection ½ / ¾ inch or hose ½ / ¾ inch
programming	The programming	Using the keypad, 4 function keys, 5 keys to set values​​, the two modes of operation
	programmable parameters: temperature correction flow coefficient	+/- 5 °C 10.0 - 90.0 typical: 74.0 for ½ inch                                    18.0 for ¾ inch
Setting	set to size: The flow rate	0.1 - 60.0 l/min.
water pressure	maximum	5 bar
flow	minimum	0.1 l/min
	maximum	60.0 l/min
	measurement error	+/-1.5%
Power Supply	voltage	230VAC +/-10% 50Hz
	Maximum power consumption	8VA
alarms	Over range (alarm at 97 deg C)	Intermittent light and audible signal
	Temperature sensor failure	Intermittent light and audible signal
	No signal from flow sensor with an open discharge	Intermittent light signal
	Presentation by signals from the sensor with a closed discharge	Continuous light signal and the intermittent sound
other	memory	Protection against loss of supply voltage, nonvolatile flash memory parameter setting value Memory of last 100 operations
	digital display	3 + 2 digits (red 14 mm)
	degree of protection	From the front IP54, IP20 total
	installation Category	I
	degree of pollution	I
	fuse	2 x 600 mA type M or T
	operating temperature	0 - 45 ° C
	humidity	80% without condensation
	weight	3.2 kg - 1/2 inch policarbonate 4 kg - 1/2 inch stainless steel 4.7 kg - 3/4 inch policarbonate 5,5 kg - 3/4 inch stainless steel
	Case Size	WxSxG (190x380x130mm) PC WxSxG (210x380x170mm) st. steel
	housing material	PC (polycarbonate) or stainless steel
	Hole Spacing	355 mm PC, 335 st.steel
	Faceplate Color	gray